This article explains project-level settings for roll products (carpet/vinyl) in MeasureSquare 8.
Project level settings refer to parameters that will affect only the current project. These changes will override System-level settings.
To establish project-level estimation settings for roll products, click the product dropdown and select a roll product, then click the gear button.
To change the setting for any of the menu options, click the down arrow to the far right of the field to make a selection.

Max T Seam Count - Controls the Maximum Number of auto-generated T Seams in a room or area. Use the dropdown or type in a number to set.
Cut Margin Type - Specifies which dimension(s) to add a cut margin to. Click the dropdown to select from None, Length Only, Width Only, or Length & Width.
Cut Margin - The extra space added to cuts along width/length dimensions to accommodate trimming with some tolerance.
Width Margin - Roll joint tolerance for the width dimension (amount to be deducted from the total cut width).
Length Margin - Roll joint tolerance for the length dimension (amount to be deducted from the total cut length).
Note: Width and Length Margins can be used when receiving rolls that have been damaged during shipping, to account for the portion(s) that will not be used).Roll Length Option - Options to control roll length.
None: Will cut and layout with the estimating length of the product.
Half Length: Will use half length rolls if possible.
Roll Allocation: Input currently available roll lengths if possible.
Attic Stock Percentage: The extra percentage to apply after layout.
Min Reusable Length: Controls whether the remnant of rolls will be counted as waste. If the length of remnant is smaller than this value, it will be counted as waste and vice versa.
Max Roll-Cut Length: It controls the maximum length of a roll cut to facilitate installation. Using Square off Wedge Cuts gives complex roll-cuts more space and increases waste allowance.
Max Carry Distance: Limits the carry distance when wedging cuts.
Roll-Cut Option: Controls how the waste will be spread, restricted to the same room or tabs or across all tabs.
None: The software will always reuse remnants of materials without any limitations. This should theoretically result in the lowest waste.
By Tab: Remnants of materials will only be reused within the same tab. It won't use leftover materials from other tabs.
By Room: The remnants of materials will only be reused within the same room. Leftover materials from other rooms won't be used, which could potentially lead to the highest waste.
Roll-Cut Round Up: The length of roll cuts will be rounded up to the multiple of entered value.
Always Round up Roll Cut: If toggled on, round roll cuts automatically (if possible). To move cuts to arbitrary position, press CTRL while dragging cuts on the Cut View.
Linear Length Round Up: The roll linear length will be rounded up to the multiple of entered value.