My laser is not connecting with MeasureSquare 8. What steps can I take to try to reconnect

My laser is not connecting with MeasureSquare 8. What steps can I take to try to reconnect

In this article we will list a few different steps you can take to recalibrate your connection to your laser measuring device. 
This article applies to Measuresquare 8

Note: It is important to know that not every laser is supported with our system. For a complete list of laser compatibility look here

Compatible lasers for Measuresquare 8:
Leica Disto D1
Leica Disto D2
Leica Disto E7100i
Leica Disto E7500i

  1. Check the compatible laser list and find your laser
  2. update Measuresquare 8 to the newest version
  3. Turn off your Bluetooth setting on both devices, wait 10 seconds, then turn Bluetooth on again
  4. Try again with a fresh set of batteries for your laser
  5. Test your lasers connection to another device
  6. Test your computers connection with a different laser
  7. RESTART your computer and try to connect again
If you are not met with success after following these steps, you may uninstall Measuresquare 8 and reinstall as a final attempt. After all steps have been attempted, you may contact the Measuresquare support hotline (626) 683-9188 ext. 3