How to add moisture task reading for JobTrakr Web?

In this article, we will show you how to add a reading for the moisture task.

This article applies to JobTrakr Web

Step 1: Click on the pin, we will see the task detail for the moisture testing > Click on Add Reading on the top right

Step 2: Click on Add Reading on the top right

Step 3: For the RH test type, you can manually type in your values in each field. We can also access calcium chloride tests if needed by tapping CaCl. Let’s focus on our Rh testing. Here you can type in the value for RH in concrete, Concrete Temp, Ambient Temp, concrete surface temp if you are concerned about that value for epoxy floors, Ambient RH and at the end you will see a timestamp that gets baked in and then click Save when you’re done.

When I deselect that probe site that pin is now showing up green within the room so that let me know that site is ready to go. If it was outside of the range, that droplet would show up as red. If you do need to do a follow up reading, you can just go here and click on Add Reading again, it will timestamp that new reading, you take the follow up reading , click Save. Within that task detail, you’re gonna have a reading history that you’ve completed and you can click add photo to add photos of your probe site.